Mobile Phone Charger
All  1-3  4-10

Previous
Next
 From:  Lish (KHOLISH)
1105.4 In reply to 1105.3 
- but seems you must make something like 50% reduction for avoid Aliasing ;)

Hi Pilou, sorry,,,,could you explain to me about "50% reduction for avoid Aliasing" ?
Do you mean for the sharp edge or ... ?

Thanks

Regards,
Lish

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Frenchy Pilou (PILOU)
1105.5 In reply to 1105.4 
Just for the visual aspect and reduct the "stairs effect" :) No more ;)
---
Pilou
Is beautiful that please without concept!
My Gallery
Attachments:

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Lish (KHOLISH)
1105.6 In reply to 1105.5 
Hi Pilou & All Forum member...

So, could you give me some tips to reduce stairs effect ?

Regards,
Lish

Attachments:

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  tyglik
1105.7 In reply to 1105.6 
I guess, Pilou just meant you could scale the image down (e.g. in Photoshop) before sending it here :)
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Message 1105.8 deleted 10 Nov 2007 by KNIGHTXOR

Previous
Next
 From:  Val (GAT)
1105.9 
Change mesh angle down to a lower number in the settings, it will slow down frame rate, but make it look smoother.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  jbshorty
1105.10 
Hi Lish. It seems you have at least one surface which is folding back onto itself. Perhaps it will join up as a closed polysurface, but this will be a problem if you try to run a fillet or chamfer. Also it may create very heavy mesh when you export. I am guessing you made that surface using Network or Sweep with 2 rails? This can create problems when making a 3 sided surface . I would suggest you create a new 4-sided surface which extends beyond those edges and then trim away the excess. That is best way to avoid folding near a singularity...

jonah
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1-3  4-10