Good evening, (ici en France il est 19h00!)

On the edge of a surface, I have an uninterrupted edge, with a small edge that goes in another direction. So I can't join the different faces of my object to make it a solid. I hope the pictures will clarify my point. otherwise I can add the surface in question.

Note: the trapezium above the interrupted edge is a void. I can still create a face, but I can't get a solid.

- Zooen

There, I isolated the surface in question, we can see the problem better (well, I think).

- Zooen

Kill the little segment
Show Points of the 2 segments
Select the 2 curves
Press Tab Write merge ?
or Maybe extend ?

but without the file it's some difficult to say exactly :)

Hi Zooen, can you please post the .3dm model file with the object in it that you show in the screenshots?

It will be a lot easier to understand the problem and to offer potential solutions if I can examine the actual model.

Thanks,
- Michael

Pilou, these are edges, not curves!
- Zooen

Michael,
Sent in PM.
- Zooen