[Feature Request] Rhino command : "Contour"
All  1-2  3

 From:  DennisD
102.3 In reply to 102.2 
Hi Michael!!!!!

Yes i need these to create contour curves of a surface or from a polysurface.

Michael please , i know that u have ALOT of work , but only until this command is available i can TRASH
the software Rhino (for me too EXPANSIVE) .

Best Regards
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Reply to All Reply to All


Show messages: All  1-2  3