First project + Renders
All  1-7  8-10

Previous
Next
 From:  Michael Gibson
101.8 In reply to 101.1 
Very nice renders!!!

I'm afraid that it's going to be a little while for most of your requests, except IGES export should be coming soon and I should be able to to a project curve in not too long.

For extend by arc, try Draw curve / Arc / Cont (continue) - this lets you draw an arc that is tangent off the end of an existing curve.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Little
101.9 
2 Michael (MMHS)
Several days. This is not composite model. In essence I used Boolean and Loft/Sweep.
Difficulties were only in the center section of the remote - with the buttons. There it was necessary to construct many additional surfaces, that to use Trim and Boolean.

2 Michael Gibson
Thanks for your help!
I will try.


And final composition especially for you :)

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Michael Gibson
101.10 In reply to 101.9 
> And final composition especially for you :)

Very nice!
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1-7  8-10