Hi Barry,

I have a node for selecting faces and edges, but not ready for release. It is based on Karsten's info node. It creates a copy of a face, then turns it into a surface with edges. The edges are copies of straight curves. The subobjects are orphaned from the main object, meaning the factory functions would not work.

Wayne

Hi Wayne,
thanks for the reply I've been able to get my desired result using the fillet2 node.
In Construct2 there are fillet & fillet2 nodes and fillet2 works but not fillet so was not sure if I am using it correctly or if its obsolete.
Many thanks
Barry