Ventilation slot
 All  1  2-6

Previous
Next
 From:  Frenchy Pilou (PILOU) 5 Jan 2020  (2 of 6) 
9637.2 In reply to 9637.1 
Maybe like this...(Trim the extremities of the Offsets)
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Barry-H 5 Jan 2020  (3 of 6) 
9637.3 In reply to 9637.1 
Hi,
the attached was done with sweep if it's what you want I will post how to produced it.
Cheers
Barry
Attachments:
AttachmentVent.zip
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Apophis 6 Jan 2020  (4 of 6) 
9637.4 
Thank you all.
Barry it would be nice if you could post a walktrough. The result and the wire mesh look good.

Cheers
Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Barry-H 6 Jan 2020  (5 of 6) 
9637.5 In reply to 9637.4 
Hi Michael,
this is the method I used make sure the rail is long than required to allow for the Boolean operation.





Cheers
Barry
Attachments:
AttachmentScreenshot (376).png
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Apophis 6 Jan 2020  (6 of 6) 
9637.6 
Thanks! Looks good.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1  2-6