Hi,
I'm having a problem with the offset node flip option not working below 0.1 .
The offset both sides works perfectly at below 0.1 ?
I searched forum for solution but found nothing.
Any help appreciated.
Barry

Yes there is something wrong in the node Offset! :(

Hi Barry.

There is a simple solution, look attached screenshots on them in the line 546 there is a value, it is circled, increase it as you need.
This will allow you to work with less indentation, but it will still stop.

Note: the line number may be different in your files because I changed my file.
Look from the line with "//mLoft2".

Hi WN,
thanks I had already found that line and modified it but not being a coder wasn’t sure I was doing the right thing but it does work.
I increased it to 100.
Is this a pick point position for the offset to know which side to offset ?
Again thanks for having a look.
Cheers
Barry

Thank you, James.

:-)

Thank you, WN.

:-)

Hi,
I am trying to count the one's in the array is this possible ?
Cheers
Barry

Barry,

You could use Split Node to select only the ones
& then Length Node to give the quantity.

James
https://www.instagram.com/nodeology/

Thanks James,
work great.
Cheers
Barry

Hello All,

It seems I cannot find "Clone ToPts" Where should I look for it?

Hi Psygorn,

CloneToPts is in the points menu.

Wayne

Hi wayne hill (WAYNEHILL5202),

Thank you so much.

Hello James,

I tried to recreate what you have created here: https://www.instagram.com/p/CarUhPAPopQ/
(Explode Move)

I can see a much simpler shape on Moi3D view ports and it does no move! (it is not dynamic although I used Quartz node just like u used) my output says "12" not "320". What am I doing wrong?

Node file is attached.

Psygorn

Yes the more objects elements, the slower the animation due the increased computational load;
so I sped up playback of output animation in post-production (iMovie).

Try these values in Basic/Quartz:

Start 0
End 5
Step 0.1
Mode Tic-tac

Have a great weekend
James
https://www.instagram.com/nodeology/