Community advice on the best way to create this shape...
 All  1  2-4

Previous
Next
 From:  amur (STEFAN) 20 Jul 2018  (2 of 4) 
9013.2 
Hi,

maybe where the parts meet trim away a bit at both parts and then do a blend.

Or use after boolean operations a large fillet.

Regards
Stefan
some 3D doodles my keybase page
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Jordan (INSIDEJOBFILMS) 20 Jul 2018  (3 of 4) 
9013.3 In reply to 9013.2 
Thanks Stefan - I will give that a try!
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  BurrMan 20 Jul 2018  (4 of 4) 
9013.4 In reply to 9013.3 
Your riser has tiny little fillets on it already so you are kindof boxing yourself in...

You could grab the profile in its current state and rebuild it and re extrude or whatever to get rid of the seems there.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1  2-4