htm for Voronoi script
  1-6  7-26  27-31

Previous
Next
 From:  glmr 28 Feb 2018  (27 of 31) 
8846.27 
Voronoi script works good in Moi3d, but it is not easy to convert angles to rounded angles. delcorners script works too strong and make a fillet for each angle takes a lot of time. for this reasn I'm looking for a solution
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  mkdm 28 Feb 2018  (28 of 31) 
8846.28 In reply to 8846.27 
Hi glmr.

I've trick that works in some situation!

Check the thread "Little Tips & Tricks :)" in a few minutes.

- Marco (mkdm)
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  mkdm 28 Feb 2018  (29 of 31) 
8846.29 In reply to 8846.27 
Check this new post : http://moi3d.com/forum/index.php?webtag=MOI&msg=8847.22

- Marco (mkdm)
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  glmr 28 Feb 2018  (30 of 31) 
8846.30 In reply to 8846.29 
thanks. sometimes it could help, but for bigger patterns it would be good to find anther way foorr smoothing angles
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  glmr 28 Feb 2018  (31 of 31) 
8846.31 In reply to 8846.29 
so, I checked, thank you.
also I used explode move for make a distance between sections
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages:  1-6  7-26  27-31