bas relief test
  1-10  11-30  31-32

Previous
Next
 From:  3dcnc 26 Feb 2018  (31 of 32) 
8834.31 
one solution is here

https://youtu.be/ZXPn2PF_Wy4


http://3d-relief.blogspot.co.uk/2012/03/video-tutorials.html


I would assume you could create an image and use Rhino to apply the image as displacement- if you needed a nurbs surface. - not tested by me. I would just use the mesh

EDITED: 26 Feb 2018 by 3DCNC
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  amur (STEFAN) 27 Feb 2018  (32 of 32) 
8834.32 In reply to 8834.31 
> one solution is here

i would say one solution was there.

Regards
Stefan
some 3D doodles my keybase page
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages:  1-10  11-30  31-32