Bottle Feed Screw
 1-10  …  31-50  51-70  71-73

Previous
Next
 From:  BurrMan
8430.71 In reply to 8430.68 
Hi Barry,
Thanks for the breakdown. That will help me alot!
The animation is simlab. They have a simulation workbench, but i wont move there until i get the setup correct.

@nico

"My screw is malformed".... Yes!
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  BurrMan
8430.72 In reply to 8430.69 
Hey Nico,
""""My first test produces a flying bottle"""""

Have you made you plug a little bigger than your bottle?

I dont think 2 objects the same size would work in a proper sim environment...
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Barry-H
8430.73 
Hi,
this is the result of lofting the facet edges to produce the scrolls.I reduced number of facets to 40 per coil
and made sure the seams of the bottle and the Can where not part of the subtraction as this ends up with
the facet edges in sections.
Thanks to Brian for the help with the node editor I've got it working with the quartz node so now I can run
the animation automatically without moving a slider.
Cheers
Barry



  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages:  1-10  11-30  31-50  51-70  71-73