hi everyone!

first time i am having trouble with moi.

i got a gap between the splines i drew and the solid object that appears after extruding. the closed spline is bend whereas the extruded object is straight!

even tried to solve it by using loft and rail. same bad result though : (

i attached a screenshot. hope someone can help me out.

stan

Hi Stan, can you please post a .3dm file in it with your problem curves? It will be easier to figure out what is going on by looking at the model file rather than just a screenshot.

- Michael

Hi Stan, it is possible that this may be a display problem. Try going to Options and check the "Add detail to inflections" button, that puts a bit more detail into creating the display mesh which can fix some of these types of display issues.

But it is hard to tell just from the screenshot whether this is a display problem or a geometry creation problem - if I can get the model I could determine it more conclusively.

- Michael