Hi Eric,

If it helps you can place a plane in your model and generate an intersection curve using the Isect command 'Construct > Curve > Isect' then enable History on the Plane and the intersection curves, in that way when you move the Plane the section will update also.


Cheers

Thanks Danny,
That's helpful. I have not used Isect before. A good tool.
eric

DannyT, can you walk me through this? I can't seem to get the section to update.

Hi beanworks, it's actually the section curves that need to be set to have history update on them, then they'll recalculate when the inputs that made them are edited.

To enable history updating on the section curves, select them and run the Edit > History command and click the "Enable update" button.

- Michael

Thanks Michael.

-

ok, got it. Thank you!