Pulling my hair out, problem using Boolean Diff
 All  1-2  3-6

Previous
Next
 From:  Michael Gibson 30 Jan 2012  (3 of 6) 
4878.3 In reply to 4878.2 
Or I guess the other way you could do it would be to make the recessed areas slightly larger so there was a little bit of open space there where their corners run into each other rather than each corner touching the other right along a single edge.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  stevecim 31 Jan 2012  (4 of 6) 
4878.4 In reply to 4878.2 
thanks , Michael

I'm working in mm how small a gap can I make, would .01 mm work?

Cheers, Steve
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson 31 Jan 2012  (5 of 6) 
4878.5 In reply to 4878.4 
Hi Steve,

> I'm working in mm how small a gap can I make, would .01 mm work?

Yeah that should likely be ok.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  stevecim 31 Jan 2012  (6 of 6) 
4878.6 In reply to 4878.5 
making sure there where gaps between object did the job.
thanks. Michael.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1-2  3-6