Thx for the infos
So waiting the next beta :)
For the moment best solution is to increase slicy the surface's size!
Because position of the object can be important for other thing :)

Kill the back face of the box don't works for me : calculate is done and finished but nothing is drawn :)

Hi Pilou,

> Kill the back face of the box don't works for me : calculate is
> done and finished but nothing is drawn :)

It's the bottom face that you need to remove, not the back face - see the attachment here.

- Michael

looking forward to the next beta then. :-)

Peace,
Rich_Art. ;)

Effectively i have erased the bad face :D
Works fine with the good face :)

And the cool thing is this erased face becomes living in the result!
Is that normal?

Hi Pilou,

> And the cool thing is this erased face becomes living in the result!
> Is that normal?

Sorry, I'm not sure if I understand this part...

The erased face becomes this totally squished down area in the result:



- Michael

Ah yes as my sphere as the same color than the box, I don't seen the empty faces!

Hi Pilou,

> At the start you have a box wihout a face (killed)
> At the end the box flowed has all faces around the sphere

Yes, that's correct - that's because the face that was empty is compressed down to a single line in the final result.

There are no new faces being created - each face in the original shape corresponds to a face in the final result.

- Michael

Ah yes! as my sphere as the same color than the box, I don't seen the empty faces! :)
It's for that I had believed that was magic!