Extruding a solid
 All  1-3  4-5

Previous
Next
 From:  Frenchy Pilou (PILOU) 4 Jul 2011  (4 of 5) 
4367.4 
It's here the problem ;)
Make zoom / show point and you will see that curve is not closed
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Michael Gibson 4 Jul 2011  (5 of 5) 
4367.5 In reply to 4367.1 
Hi Mark, just to help clarify a couple more screenshots:






If you can get that area cleaned up so that it is a completely closed curve then it should extrude as a solid with end caps on it.

- Michael

  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1-3  4-5