Hi,

I try to make an Audi TT.

The curve around the whole car fits very good together in top and right view, but the curve for the car top does in my opinion not correspond. Does I see it wrong?

In my opinion the curve must end, where the red arrow is.

RUdl

Hi Rudl, it may not be too unusual for somewhat casual blueprint images like that to be a bit imprecise, is that the problem that you don't think the blueprint is correct?

If the blueprint image is not 100% accurate in small areas you may need to just use your own judgment in those spots.

- Michael

Thank you,

yes, this was the problem. So I will have to interpolate.

Rudl