thank you for the hint! i didnt know that i could use fillet between surfaces.. i guess i am on the way now :)

Hi ello, it can be a bit tricky though since you end up with a lot of small pieces that need to be managed and trimmed.

If you can let me know what radius value you wanted the fillet to be, I could give it a try to see if it is going to be feasible or not.

- Michael

Hi Michael,

i managed to create it by using a mix of sweep, network (for the rounded edges) and loft. i created curves for all the tricky places. finally i joined all the surfaces and now i have a quite nice surface i can work on with...


cheers,
Ello