>Ideally this command would allow you to tell it
>either a number of control points or a tolerance
>value and it would create a new curve that followed the shape of the old one.

So multi-purpose command again and again...
I like this MoI's feature....and your programming approach that can be worded as "measure twice, cut once" as well.

Petr

Hi Petr,

> So multi-purpose command again and again...

Yup, I've found that this is a really important goal. It's one of the things that makes a more streamlined (and along with that easier to use) UI - trying to get more use and "value" out of each little bit.

> I like this MoI's feature....and your programming approach that can
> be worded as "measure twice, cut once" as well.

Thanks! Yup, I think that's pretty close. Similar to carpentry it helps to reduce different kinds of waste.

- Michael