> Seems you have not put the F11 as Full screen? :)

I'm a little bit worried about putting it in by default... If someone accidentally hit it there isn't anything available on the screen to get out of the full screen mode.

It probably needs to wait until it gets some UI on the screen to restore it before I can put it in by default.

But if you set it up yourself, it won't be a surprise...

- Michael

>Ideally this command would allow you to tell it
>either a number of control points or a tolerance
>value and it would create a new curve that followed the shape of the old one.

So multi-purpose command again and again...
I like this MoI's feature....and your programming approach that can be worded as "measure twice, cut once" as well.

Petr

Hi Petr,

> So multi-purpose command again and again...

Yup, I've found that this is a really important goal. It's one of the things that makes a more streamlined (and along with that easier to use) UI - trying to get more use and "value" out of each little bit.

> I like this MoI's feature....and your programming approach that can
> be worded as "measure twice, cut once" as well.

Thanks! Yup, I think that's pretty close. Similar to carpentry it helps to reduce different kinds of waste.

- Michael