So attached is sample of parting surface.

Hi Anis,

Yep, that's the parting face, you've got the idea, the only thing I did was to smooth out the area shown in the picture, there is sort of a kink in this area resulting from the offset, this is not nice for mould makers in regards to machining the face and fitting afterward so I refined this area a little to get more of a smoother surface that follows the spoon shape.



I've attached that part of the surface with a refined version for you to have a look.

Cheers

Hi Danny,

How do create those surface in MoI ?
Or are you create the offset surface in NX ?

Hi Anis,

Everything is done in MoI, I offset the part line and smooth it out using the control points.

Cheers