Solid ???
All  1-10  11-13

Previous
Next
 From:  Michael Gibson
1880.11 In reply to 1880.9 
Hi Danny, looking at all the surface control points for other surfaces, it looks like this may be a section from what started out as a thicker object then was cut down with a boolean?

If you happen to have an earlier version of the object before that boolean, that could help if you could send that to me and I can see if I can recreate the problem.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  DannyT (DANTAS)
1880.12 In reply to 1880.11 
Hi Michael,

I'll try and recall the steps I took there, the model I posted is just I piece I cut off the main model, I can send you the whole model if you like.

.
~Danny~
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Michael Gibson
1880.13 In reply to 1880.12 
Hi Danny,

> the model I posted is just I piece I cut off the main
> model, I can send you the whole model if you like.

Yeah, if it is ok please send it to me at moi@moi3d.com, I can try to see if I can recreate the problem surface.

If I can find the steps to make it happen, it will help a lot to try and find the bug.

Thanks,

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

 
 
Show messages: All  1-10  11-13