How can I do like Rhino's "VariableFillet"?
 All  1-2  3-6

Previous
Next
 From:  Michael T. (MICTU_UTCIM) 12 Mar 2008  (3 of 6) 
1444.3 
Hi all!

You can take the long way around with some surface trimming and then using the sweep command like I show in the attached JPEG. I could end up being a lot of work depending on the complexity of your surfaces, but this might help for the time being until V2.0 is out.


Michael Tuttle a.k.a. mictu http://www.coroflot.com/fish317537

EDITED: 4 Nov 2010 by MICTU_UTCIM
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Jason (JASONSHOW) 12 Mar 2008  (4 of 6) 
1444.4 In reply to 1444.3 
mictu,
this is COOL !!
thanks!
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael T. (MICTU_UTCIM) 13 Mar 2008  (5 of 6) 
1444.5 In reply to 1444.4 
Thanks Jason. Hope it helped.
Michael Tuttle a.k.a. mictu http://www.coroflot.com/fish317537
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Basic Slave (CREATIVECONTROL) 13 Mar 2008  (6 of 6) 
1444.6 In reply to 1444.2 
Thanks Michael, a variable fillet would be much appreciated. Looking forward to it!
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1-2  3-6