Ducted Fan System 3D Print

Next
 From:  summarity 23 Jun  (1 of 5) 
12028.1 
A few snaps from my weekend project with MoI 5 - replacing my noisy Amazon ducted inline fan unit with a custom, low-noise version using a standard 140mm PC fan.

Mounts magnetically (10x2mm magnets), print time ~6 hours for the largest part using PET-GF15. Used to distribute cold air from the only room with aircon into others using 100mm OD flex ducting.

MoI screenshot: https://avm-cdn.com/images/fan%20duct%20sh.png

Assembly: https://avm-cdn.com/images/fan%20duct%20fd%20build%20clip.mp4

Timelapse 1: https://avm-cdn.com/images/fan%20duct%20tl%201.mp4

Timelapse 2: https://avm-cdn.com/images/fan%20duct%20tl%202.mp4
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Ken (OKURO) 23 Jun  (2 of 5) 
12028.2 In reply to 12028.1 
Congrats ! Very well done !!!
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Frenchy Pilou (PILOU) 23 Jun  (3 of 5) 
12028.3 
Excellent!
---
Pilou
Is beautiful that please without concept!
My Moi French Site
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Michael Gibson 23 Jun  (4 of 5) 
12028.4 In reply to 12028.1 
Turned out great! Thanks for showing it.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Matadem 23 Jun  (5 of 5) 
12028.5 
Printed quite nice.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All