diameter or radius

Next
 From:  simon (NOAH) 15 Jan  (1 of 4) 
11904.1 
Hi.
IS it possible to make the circle tool default to DIAMETER rather than going back to RADIUS all the time?
Thanks in advance.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  pressure (PEER) 15 Jan  (2 of 4) 
11904.2 In reply to 11904.1 
Set UseDiameterDefault=y under [Commands] in moi.ini which is accessed by going to Options > General > "Edit .ini file"

- Peer
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
Next
 From:  Rusty (13BRV3) 16 Jan  (3 of 4) 
11904.3 
I've been meaning to ask the same question, so thanks to you both!
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  simon (NOAH) 16 Jan  (4 of 4) 
11904.4 
Thanks Peer!
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All