Expand a volume (offset object walls without creating a shell)
 All  1-4  5-6

Previous
Next
 From:  tennet (FREDERIK) 3 Jun  (5 of 6) 
11755.5 
Thanks again!
I thought "offset" created a shell as well, but it was just the original volume that I was seeing on the inside – my bad.
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  shayno 10 Jun  (6 of 6) 
11755.6 
Have you tried the ScaleIndividual command ?

You can input a percentage

It works well on multiple parts also, scaling them each around their centre

cheers
shayne
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1-4  5-6