Can't get repeatable concentric pattern cut
 All  1-7  8-9

Previous
Next
 From:  Matadem 29 Jun 2022  (8 of 9) 
10748.8 In reply to 10748.7 
Good day.
you might need to check how accurate your machine is and if it can produce repeatable results and go from there.

I do suggest that you perform these tests... this is an avid machine but the test can be applied to your machine as well.

https://www.youtube.com/watch?v=E5H7Fsrq95c
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  gunter511 30 Jun 2022  (9 of 9) 
10748.9 In reply to 10748.8 
That's a really great calibration set up! You're using Mach 4 in your set up .. I'm on GBRL.. I have to figure out how to count steps!
Thank you for your youtube link!
Gunter
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1-7  8-9