>> Is it possible to rotate the leaves using your nodes?
Yes, Change the "Aperture" value. Also, use the other blue nodes as well. E.g "Leaves", "Height"

Hi MO,

I did use Aperture but it seems the leaves are rotated around the center, I mean they are not rotated around a pivot point on the lateral side of the sphere! ( I hope this explanation is good)

However, the way leaves rotate using your nodes is another type of movement which is interesting in its own rights! :-) And I can tell u it is possible to make a 3D printable design with such movement.

- Psygorn

Hi
>> it seems the leaves are rotated around the center
I guess you are using the "Iris_Box_3" node. I used the center point as anchor point there.

But you can see the anchor point in other nodes shown by a little cylinder.

>> it is possible to make a 3D printable design with such movement.
Cool! :)
It can handle up to 60 leaves!

Hi,

> But you can see the anchor point in other nodes shown by a little cylinder.

Yes, I saw it. :-) in "Iris_Box_4 node" it seems it works fine! (Or at least I am sure with your Nodes one can make as many Iris_Dome_Box designs as he/she wants) great job! :-)

>It can handle up to 60 leaves!

Let's make that one! :D

- Psygorn

>> Let's make that one! :D

35 Leaves :)

Isn't it satisfying?

:-)