keeping two faces connected when extruding
 All  1  2-3

Previous
Next
 From:  Michael Gibson 17 Feb 2022  (2 of 3) 
10591.2 In reply to 10591.1 
Hi Xenon472, try using the Construct > Offset > Shell command rather than Extrude.

- Michael
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged

Previous
 From:  Death 17 Feb 2022  (3 of 3) 
10591.3 In reply to 10591.1 
Also, you can select the 2 faces (in top view), then select extrude and extrude downwards in the front view...
  Reply Reply More Options
Post Options
Reply as PM Reply as PM
Print Print
Mark as unread Mark as unread
Relationship Relationship
IP Logged
 

Reply to All Reply to All

 

  
 
Show messages: All  1  2-3