Hi Michael,
Just saw your reply. I did actually move the cylinder off center to avoid the overlap,
instead of trimming. But thanks for mentioning the "ShrinkTrimmedSrf". I was
runnning in a situation where this probably would have been the solution. I just
could not remember the command. Don't need this too often.
But there is another question that came up in regards to the overlapping cylinders.
Does Moi first Boolean Union internally the cylinders before subtracting from the ring? I am
just asking out of curiosity, because this would make more sense to me why there is
a conflict, since those are all individual cylinders.
Ad
|
