Show messages: All
1-2
3-12
From: AlexPolo
Thanks Michael - appreciate the remedy.
regards
Alex.
From: Michael Gibson
Hi Alex, also it seems that it's a combination of the holes being small and also that they're made up of several edges. If you run the Merge command on your surface that will combine them into one edge and it will shell ok after that.
I've added this case to my list to investigate after v4 is wrapped up to see if I can make the original one work.
- Michael
From: AlexPolo
Once again thanks for your knowledge and remedy here is full project will post pictures once manufactured but 100% designed in MOI.
From: Michael Gibson
You're welcome Alex, I'm looking forward to pics!
- Michael
From: AlexPolo
This whole project was designed in MOI all sheetmetal parts - following a few simple rules sheetmetal is easy within MOI. I plan on putting together a workflow for sheetmetal using MOI shortly. Here are progress shots.
Image Attachments:
IMG_20200820_133344621.jpg
IMG_20200914_135415165.jpg
IMG_20200921_101417840.jpg
From: Frenchy Pilou (PILOU)
Cool design!
From: Michael Gibson
Hi Alex, wow that is awesome! It would be cool to see it when it's finished too!
- Michael
From: BurrMan
Nice!
From: stefano (LIGHTWAVE)
Top Stuff Alex, nice to see built reality!
From: Cemortan_Tudor
wow !
Show messages: All
1-2
3-12