Show messages: All
1-9
10
From: Bazzer (BARRIELEVER)
Hello Michael and Anthony
Thanks for your help with the spinner prop project, I have got a result that I think I can forward to tool production with.
I used a blended surface, I trimmed a cut out in the cone to 0.75mm bigger than where the blade joined and then trimmed the blade out by 0.75mm and then blended between the two.
I can see that my modelling skills need refining somewhat going forwards.
Best Regards
Barrie
Image Attachments:
fillet.jpg
fillet_trailing_edge.jpg
Show messages: All
1-9
10