Show messages: All
1-3
4-6
From: ed (EDDYF)
I think what Yuri is saying is that whenever you draw a circle, the measurement defaults to radius, and you have to click to switch the value to diameter.
I would also like to see an ini setting to default to diameter. Most of the circles I draw are for bolt holes, and therefore I'm looking to directly specify a diameter.
Ed Ferguson
From: Michael Gibson
Hi Mr. Yuri, yes it's in the moi.ini file under:
[Commands]
UseDiameterDefault=n
Switch that to =y and then it should use diameter as the default radial input method.
- Michael
From: Mr. Yuri (MR_JURAJ)
Thanks Michael,
that's what I've been lookin for ;)
Show messages: All
1-3
4-6