Full Version: Boolean Diff

Show messages: All  1  2-6

Your objects are "tangent" just increase Scale 1D and that will works! ;)

---

Thanks so much Pilou!

Just tried Larger and smaller and works!

Image Attachments:
Image2.jpg 

---

Hi JoeZ, it sounds like you've got it figured out, but yes it can be difficult for booleans to handle cases where 2 surfaces are just barely skimming each other with overlapping surface areas. That's a more difficult case for surface/surface intersection to handle.

So it is good to push objects through each other with a little clearance if possible.

- Michael

---

Thank you Michael!
And thanks for this forum!
I appreciate all the support!
I've learned so much, reading the post in it, almost daily!

---

>>I've learned so much, reading the post in it, almost daily!

Same for me Jose, this forum is a goldmine :)

---

Show messages: All  1  2-6