Show messages: All
1-3
4-7
From: FED
Hi Michael-
I am sorry for asking another question, but I cannot seem to get the blend command to work on two cylinders at 90 degrees corners.
I tried the suggestions, but could you look? I have attached the file.
Again, I am new to modeling but truly enjoy MOI. MOI has really helped me to see design in a new way and learn about computer modeling. Truly lots of fun learning new techniques!!
best,
FED
Attachments:
Blend Test.3dm
From: Michael Gibson
Hi FED, do you mean this one here? :
To make that blend you'll need to delete the original circle curves, delete the end caps, then select the 2 edges and run the Construct > Blend command, here is an example video of the entire sequence:
Hope this helps!
- Michael
Image Attachments:
FED_blend1.jpg
From: FED
Hi Michael-
Thank you for your patience and help!!!!
Best,
FED
From: Michael Gibson
You're welcome FED!
- Michael
Show messages: All
1-3
4-7