Show messages: All
1-12
13-14
From: mat10x
Hi Pilou,
That's how I would have done that too. Was hoping for a quicker one-stop-shop method.
Thx for the vid.
From: Michael Gibson
Hi mat,
> Is it that the shape has been trimmed already on that lower front edge?
I think it's because this is a more complex area to handle, where the side wall surfaces need to be extended, rather than just having areas trimmed away:
I do hope to be able to improve that in the future but it's going to require a lot of work with integrating a different geometry kernel so I'm not sure when that will happen.
- Michael
Image Attachments:
mat_chamfer.jpg
Show messages: All
1-12
13-14