Full Version: Trimming question

From: Michael Gibson [#4]
 3 Nov
To: ALL

Hi Involute, so in the attached file I ended up using Edit > Trim to cut pieces away and then used Construct > Network to build a filling surface and joined it in.

Also instead of just drawing in a line for the top of that red zone above I put in a control point curve that's slightly curved so it's smooth with the lower piece.

- Michael

Attachments:
ConnectorTube2.3dm

Reply


Show messages: All  1-3  4

Reply to All

Back to thread list | Login

© 2017 Project Beehive Forum