Full Version: Trimming question

From: Michael Gibson [#3]
 3 Nov
To: ALL

So you'd only want to draw in lines for these spots here, the other 2 spots are slightly curved and you want to use the existing edges there rather than putting in a straight line:



- Michael

Image Attachments:
involute_cut2.jpg 

Reply


From: Michael Gibson [#4]
 3 Nov
To: ALL

Hi Involute, so in the attached file I ended up using Edit > Trim to cut pieces away and then used Construct > Network to build a filling surface and joined it in.

Also instead of just drawing in a line for the top of that red zone above I put in a control point curve that's slightly curved so it's smooth with the lower piece.

- Michael

Attachments:
ConnectorTube2.3dm

Reply


Show messages: All  1-2  3-4

Reply to All

Back to thread list | Login

© 2017 Project Beehive Forum