Show messages: All
1-4
5-6
From: bemfarmer
Finally, a ball with two holes.
Placed a sphere around one hole of the parabolic cyclide, to remove the handle, and with another sphere, did some trimming, fillet, rotate copy, etc.
- Brian
Image Attachments:
Ball2hole01.png
From: bemfarmer
.3dm of ball with holes uploaded to previous post.
Cyclides and circles and spheres tend to go together...
- Brian
Two edges fillet well. Their fillet faces were copied to fillet surfaces, rotated twice to the other hole entrance, and used
to trim the other two edges which previously did not fillet with the Fillet command.
Show messages: All
1-4
5-6