Show messages: All
1-9
10
From: Michael Gibson
Hi mantaskava, I've attached an attempt at building in a fill piece and then cutting away some space with Trim and putting in a Blend surface.
But I think it may be difficult to get a good looking transition since these areas are quite flat:
It would be good for those flat shapes to have extended further down if possible.
Or another possibility to get better shaping could be to cut away a larger space so the blend could have a larger transition from the flat areas.
- Michael
Attachments:
Table_Leg_02.3dm
Image Attachments:
mantaskava_flat.jpg
Show messages: All
1-9
10
