Show messages:
1-17
18-28
From: BurrMan
Me likey!!!
Is that render still Carrara?
From: Grendel
Yes it is....old habits die hard
From: BurrMan
I would have to say I don't think I've seen anybody render with Carrara as well as you..... I wish I was a fly on the wall in your work area for a bit....
Thanks for sharing.
From: Grendel
LOL....You would hear a lot of cursing and screaming that DAZ has let the product languish technically since they purchased it to emphasize their....."content" delivery
From: BurrMan
It would just be ambient noise while I focus on what your doing.
Ray Dream was my first 3d modeler.
From: Grendel
A quick print out of the CreatureBox JellyBean character, I used to paint warhammer figures years ago so I will break out my paints and get him colored up. The figure is about 4"" tall, I had to change the diameters on the arms cylinders and fingers to get them to be rigid enough to clean up...still has the same feel though
Image Attachments:
JB-Quarter.jpg
JB-Side.jpg
From: Michael Gibson
That is sure a nice printer you've got there.
- Michael
From: Grendel
It shows off your software nicely
From: DVR (DIGID)
Hi ,
I am using this handy plugin as well .
I am getting segmented curves in STL at diameters greater than 100mm. I did look in the script and only see angle @ 5
I typically use angle 6 , divide 1 - all and minimum .25 when exporting to get smooth curves
How do I add divide 1 - all and minimum .25 to the script?
From: Michael Gibson
Hi DVR,
re:
> How do I add divide 1 - all and minimum .25 to the script?
It would need to set up an options string that looks like this:
NoUI=true;Angle=5;MaxLength=1;MaxLengthApplyTo=all;MinLength=0.25
I've attached a modified version of the script that will do that.
- Michael
Attachments:
SaveMultiSTL.js
From: DVR (DIGID)
Thank You Michael!
This works brilliant . Do not have to remember the settings anymore
Show messages:
1-17
18-28
