Show messages: All
1-2
3-4
From: pafurijaz
I didn't have any problems before either, suddenly I can't open DXF files anymore.
I see now that there are some reports, but it closes immediately and doesn't create new reports.
I send you these maybe there is also something in these to check.
Thank you and greetings.
Attachments:
moi_report3.zip
From: Michael Gibson
Hi pafurijaz, I think I may have found the problem, I've sent you a private forum message with a test patch in it.
The DXF code had some old 32-bit memory alignment stuff in it, which is a error on 64-bit but often silently tolerated depending on processor and operating system.
Thanks,
- Michael
Show messages: All
1-2
3-4