Show messages: All
1
2-6
From: Michael Gibson
Hi Andy, it's a lot more difficult for booleans to handle things that have coincident or nearly coincident surface areas.
So for your cut piece it would be good for it to be 2mm thick with 1mm going down like you have now but the other side 1mm above rather than flush.
Does it work ok if you get it set up like that?
- Michael
Message 11022.3 was deleted
From: Michael Gibson
HI Andy, if you turn on control points for the curves you can see 2 red squares:
Those are spots that have several curve control points stacked up on top of each other. They may need to be cleaned up first.
- Michael
Image Attachments:
stacked_points.png
From: Michael Gibson
Hi Andy try with this one.
- Michael
Attachments:
Cap-BeforeBoolean-3_3dm.zip
From: Andy (ANDYA)
Many thanks Michael - works great! Andy
Show messages: All
1
2-6