Show messages:
1
2-21
22-41
42-43
From: Michael Gibson
Hi Pilou,
re:
> Of course yes...it was for the concept! :)
Ok, but this discussion thread is about this specific model.
> else does it normal that a volume "subdivided" even with a low subdivision
> can't be filleted ?
It's normal that you can't place an edge fillet along an edge that is already smooth between the 2 surfaces that it belongs to.
That control is not for controlling the amount of subdivision, it's for controlling a weighting effect. In a case like you show there with a value of 6 the surfaces are still smooth where they meet, their curvature is just more tightly bunched into a smaller area. If you zoom in closely on a corner or an edge you should see that it still has a rounded shape there (with a kind of bump and valley), just contained in a much smaller area.
You can only apply fillets to areas of a model that are sharp, not on edges that are already smooth.
Here's what you should see if you zoom in on your object:
- Michael
Image Attachments:
pilou_subdiv1.jpg
pilou_subdiv2.jpg
From: Frenchy Pilou (PILOU)
Ok that is more clear!
Show messages:
1
2-21
22-41
42-43