Show messages:
1-20
21-40
41-44
From: Mike K4ICY (MAJIKMIKE)
Thanks Rich!
And great work yourself! Very clever stuff.
An interactive online viewer just for fun.
From: useruser
thank you very much mike! great tutorial!
but i have a little problem ( Moi-Newbie) here: i am not able to add the bottom-surface with the planarfunction and i have no idea what i am doing wrong.
thanks in advance!
Oli
Attachments:
Flasche_01.3dm
Image Attachments:
bottom.jpg
From: Mike K4ICY (MAJIKMIKE)
Thanks Oli, I hope you're able to complete the tutorial.
As for not being able to make the bottom area Planar, please look over the previous post:
http://moi3d.com/forum/index.php?webtag=MOI&msg=5530.29
If the bottom profile curves are not flat, not touching, or not tangent, then Network may not make a surface with a planar edge.
If the curves are both tangent and touching, then you can make them flat in a side view by moving the handle bar until a tab says "Flat".
If nothing works, you can also Boolean Difference, or use Trim to cut a plane away from the bad edge.
Good luck!
From: useruser
great.that works.
thank you for the quick support Mike! :)
Show messages:
1-20
21-40
41-44
