MoI discussion forum
MoI discussion forum

Full Version: Connect two faces

Show messages: All  1-10  11-12

From: Andre
13 Oct   [#11]
Here's a case where I had to resort to the line drawing method again. Granted, it's a bit of a special case.

The selected solid was made using the line drawing method. The lines are still in the file. Would there be another method available?

Attachments:
vacuum_nozzle.3dm

Image Attachments:
2026-10-13-20-20-17-MoI.png 


From: Michael Gibson
13 Oct   [#12] In reply to [#11]
Hi Andre, it can be easier to kind of go back a step and make a base shape with sharp edges and use filleting to put in the fillets rather than only trying to fill in individual pieces.

Something like this:









- Michael

Image Attachments:
andre_fillet1.png  andre_fillet2.png  andre_fillet3.png 


Show messages: All  1-10  11-12