Full Version: Not solid after boolean and clipboard question

Good day.
attached a piece that it is indicated as solid but when I boolean the orange piece is not solid anymore?

also when you copy an item does it go to the windows clipboard?
I tried it but my clipboard is empty and if it works can it be setup to be as an obj file onto the clipboard?

Tnx!

Attachments:
solid.3dm

---

Your fillets are over lapping. the model can't figure out which way is facing out.

Val

---

Hi Matadem, yes like Val says above your fillet radius is too large and there is an area with a messed up trim boundary here:






> also when you copy an item does it go to the windows clipboard?

With the Edit > Copy command or Ctrl+C / Cmd+C, yes.


> I tried it but my clipboard is empty and

What are you using to look at the clipboard?


> if it works can it be setup to be as an obj file onto the clipboard?

The .obj spec does not have anything in it about the clipboard, so it's not possible.

- Michael

Image Attachments:
Matadem_radius1.png  Matadem_radius2.png 

---