Show messages: All
1-4
5-6
From: Michael Gibson
Something like this -
Loft a cutting surface between 2 curves for the outside:
Loft a similar cutting surface for the inside:
Use Edit > Trim to cut the donut with those lofted surfaces as the cutting objects.
That will make a result like this which you can thicken using Construct > Shell :
- Michael
Image Attachments:
chris_donut1.jpg
chris_donut2.jpg
chris_donut3.jpg
chris_donut4.jpg
chris_donut5.jpg
From: twofoot
Well that was unpleasant. Thank you everyone for your help!
Chris
Show messages: All
1-4
5-6
