Show messages: All
1-4
5-9
From: gunter511
Barry, this is super helpful, thank you so much, I now understand it!
Much appreciated!
Gunter
From: Frenchy Pilou (PILOU)
Maybe another solution ;)
I don't how you have drawn your object
Here with the Blend
Like this you can test all generative curves
With your object
Extrude each oval (careful to kill the 2 curves and faces for have only edges!
Make the Blend : during it move the points where you want for move the seam!
Of course at the end kill the ovoïd cylinders! ;) (not shown here)
From: gunter511
Hi Pilou, this is great learning for me, thank you so much!
Gunter
From: shayno
Hi there
You will get a much better flow if you reduce the surface area to flow onto , just using the outside half of the band
With a lot less distortion
cheers
shayne
Image Attachments:
2024.07.25-09.28.25-[3D].jpg
Screen Shot 07-25-24 at 09.30 AM.JPG
From: gunter511
Hey Shayne, thank you so much, that makes absolute sense!
Gunter
Show messages: All
1-4
5-9