Show messages: All
1-11
12-15
From: gunter511
Suiyan, thank you! That's very helpful indeed!
From: gunter511
Hey Peer, Yes, this is exactly what I'm after, thank you very much!
From: 大道刀 (SUIYAN)
别客气，我想你该对最终效果有更清晰的认识。就是到底哪些部分应该被布尔，哪些部分被保留。这种孔的造型最好的方式应该是在还是平面时拉伸那些孔的封闭曲线（双侧），让这些柱体高度完全能穿透戒指圈的目标实体，然后对它们进行流动，使这些柱体流动至戒指圈的目标体→布尔。
这可以最大程度的简化并且避免布尔出现错误结果，虽然这次的布尔很顺利。
（Don't mention it, I think you should have a clearer understanding of the final effect. Which parts should be Boolean and which parts should be retained. The best way to shape these holes is to stretch the closed curves (on both sides) of the holes when they are still flat, so that the height of these pillars can fully penetrate the target entity of the ring ring, and then flow them so that these pillars flow to the target entity of the ring ring → Boolean.
This can simplify and avoid errors in Boolean results to the greatest extent possible, although the Boolean process went smoothly this time）
From: gunter511
Thank you Suiyan, yes, this is exactly what I tried to do and it helped.
The other thing I experimented with was rather than flowing the lattice, I extracted the diamond shapes from the lattice and extruded those. Then Flowed those onto the ring and then Boolean difference.
It's fun to try different methods!
Thanks again!
Gunter
Show messages: All
1-11
12-15
